Napoleon GSS48 Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cylinder Connection: Ensure the gas regulator hose is kink
free. Remove the cap or plug from the cylinder fuel valve.
Insert the black QCC1 regulator nipple onto the QCC1 fuel
valve. Hand tighten clockwise. Do not use tools. Leak test
all joints prior to using the appliance. A leak test must be
performed annually and each time a cylinder is hooked up
or if a part of the gas system is replaced.
If this appliance is to be connected directly to a house
propane gas supply line, follow the instructions for the
natural gas hook-up.
CAUTION!
Make sure cylinder valve is in its full off position.
(Turn clockwise to stop).
Check cylinder valve features to ensure it has proper external mating threads. (Cylinder Valve
Marked: USE WITH TYPE 1)
Inspect hose shipped with the unit for damage. Never attempt to use damaged or plugged
equipment. See your local LP Gas Dealer for repairs.
When connecting regulator assembly to the cylinder valve, hand tighten black QCC1 nut clockwise
to a positive stop. DO NOT use a wrench to tighten. Use of a wrench may damage the quick closing
coupling nut and result in a hazardous condition.
Locate the hose out of pathways where people may trip over it or in areas where the hose may be
subject to accidental damage.
Open cylinder valve fully (counter-clockwise). Turn the on/off valve at the unit slowly to the on position
and use a soapy water solution to check all connections for leaks as indicated in the diagrams before
attempting to light the appliance. If a leak is found, turn tank valve off and do not use the appliance
until repairs can be made.
19
EN
www.napoleongrills.com

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gss48st

Table des Matières