1
Service
The SPC200 Smart Positioning Controller possesses a new
operating system (firmware) with extended functions.
Please note the following service information.
1.1 Version status information
The basic units types SPC200−CPU−4 or −6 and the subcon
troller module type SPC200−SCU−AIF each have their own
operating system (firmware).
Caution
For faultless operation of the SPC200 with a subcon
troller module it is necessary that the operating system
versions are the same.
WinPISA as from version 4.3 will display a fault message if
the operating system versions are not the same when the
online mode is activated.
With WinPISA as from version 4.1, you can display the
operating system versions in active online mode in the
window SPC200 configuration" as quickinfo" (tool tip),
by placing the mouse cursor on the appropriate compo
nent.
Module SPC200−AIF−PWR:
S
Operating system version of the basic unit
Module SPC200−SCU−AIF:
S
Operating system version of the subcontroller module
Notes on compatible operating system versions, WinPISA
and manual versions can be found in the following table.
Festo SPC200−... 0504c English
informationEnglish
13