Ariston LI 641 A Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
D
1509)50-4
How to load your dishes
Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer.
Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough
incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well
First of all.
Before placing the dishes in the
racks, remove the largest scraps
of food left over on your plates, you
will thus avoid blocking the filter,
which would reduce the efficacy
of the wash.
If the saucepans and frying pans
are very dirty, allow them to soak
before being washed. To make it
easier to load your dishes, pull the
racks out.
What goes into the
lower rack?
We recommend you place the most
difficult dishes to wash into the
lower rack: saucepans, lids, soup
dishes and plates, but also: mugs,
cups and glasses (see photos for
load examples).
• Serving dishes and large
lids: place them on the sides
of the rack.
• Saucepans, salad bowls:
must always be placed upside
down
• Very deep dishes: place
them obliquely, thus allowing
water to run down them and
cleaning them better
• Glasses and cups: Position
them as indicated in the figure.
This basket is equipped with two
removable grids: insert the cutlery
one by one into the slots; knives
and utensils with sharp blades or
tips should be positioned with the
sharp parts at the bottom. Position
all cutlery items so that they don't
touch.
If the rack has side baskets, the
spoons should be loaded
individually into the appropriate
slots (see fig. A - B).
- Especially long utensils should be
placed in the horizontal position at
the front of the upper rack.
14 ARISTON DISHWASHER - Instructions for installation and use
What goes into the
upper rack?
Place delicate and lightweight
dishes in the upper rack: glasses,
tea cups and coffee cups, saucers -
but plates too - shallow salad bowls,
slightly dirty frying pans and shal-
low pans.
Position light weight dishes in such
a way as to avoid their being moved
by the spray of water.
The appliance can also be equipped
with one or two tip-up compart-
ments onto which you can place
mugs and cups, as well as long sharp
knives and serving cutlery.
After loading the dishes, remem-
ber to check that the blades on the
sprayer arms can turn freely with-
out hitting against any dishes.
How to adjust the top
rack.
The upper rack can be set in high
or low position to enable you to
organise your dishes effortlessly.
1
2
3
Fig.F
4
A1
Open the rail stop flaps and pull the
rack out completely. Now place it in
high or low position, then slide it
along the guide rails until the front
wheels also go in. Now close the rail
stop flaps. Follow the sequence of
actions illustrated in figure "F".
Load examples
lower rack
)
A A
upper rack
B

Publicité

Table des Matières
loading

Table des Matières