RIDGID K-60SP Manuel D'utilisation page 8

K-60SP Drain Cleaning Machine
pin key removed, handle should be in its upper-most
position.
NOTE! When not in use, the clutch handle should be in
its locked (down) position in order to protect
the handle and to allow the operator to carry the
unit by the clutch handle if desired.
4. Make sure FOR/OFF/REV switch is in the OFF po-
sition.
Figure 4 – Rear Guide Hose Attachment
5. Attach the rear guide hose by lifting up the lock pin
and sliding guide hose onto the jaw housing adjust-
ment knob (Figure 4).
Do not use machine without rear guide
WARNING
hose attached. Prevents cable whipping and possible en-
tanglement.
6. Insert first cable into front of machine (female end
first) and push through guide hose until approxi-
mately one foot remains out the front of the machine
(Figure 5).
Figure 5 – Inserting Cable Into Front Of Machine
1.800.561.8187
6
WARNING
time. Cable will extend behind rear guide tube.
NOTE! Adjust the jaw set as required. The K-60SP
7. Select and install the proper tool to the end of the
Figure 6 – Coupling and Uncoupling Tools
NOTE! Proper Tool Selection
8. Plug the Drain Cleaning Machine into the electrical
WARNING
fires, never use an extension cord that is damaged or
does not meet the following requirements:
• The cord has a three-prong plug similar to shown in
Electrical Safety section.
• The cord is rated as "W" or "W-A" if being used out-
doors.
• The cord has sufficient wire thickness (16 AWG below
50'/14 AWG 50' - 100'). If the wire thickness is too
small, the cord may overheat, melting the cord's insu-
lation or causing nearby objects to ignite.
WARNING
all electrical connections dry and off the ground. Do
not touch plug with wet hands. Test the Ground Fault
Circuit Interrupter (GFCI) provided with the electric cord
to insure it is operating correctly. When test button is
pushed in, the indicator light should go off. Reactivate by
pushing the reset button in. If indicator light goes on, the
machine is ready to use. If the GFCI does not function
correctly, do not use the machine.
Ridge Tool Company
www. .com
Never couple more than one cable at a
has a jaw set adjustment which allows the ma-
chine to accept 5 / " and
8
Refer to "Special Procedures" section.
cable. The T-Slot Coupler allows the tool to be
snapped into the cable coupler (Figure 6). To re-
move tool, use the pin key to depress the plunger and
slide the coupling apart.
To Couple Cable
To Uncouple Cable and Tools
and Tools
Snap Together Insert Pin
A good rule of thumb is to use a tool at least 1"
smaller than the line to be cleaned. The style of the
tool is determined by the nature of the job and is
left up to the operator.
outlet, making sure to position the power cord along
the clear path selected earlier. If the power cord
does not reach the outlet, use an extension cord in
good condition.
To avoid electric shock and electrical
To reduce risk of electrical shock, keep
information@itm.com
7 / " diameter cable.
8
Slide Apart