Accessories - RIDGID K-60SP Manuel D'utilisation

Figure 10 – Jaw Set Adjustment
5 / " Diameter Cable
8
• If the jaw set does not engage the cable when the
clutch handle is pressed, the jaw set is open too
wide.
• Remove the rear guide hose from the jaw housing
adjustment knob.
• Loosen the set screw with
• Turn the adjustment knob clockwise until the cable
is engaged by the jaw set when the clutch handle is
pressed (approximately 2 turns) (Figure 10).
• If necessary, turn the adjustment knob in the direction
required so that the clutch handle engages the cable
at the position desired by the operator.
• Tighten the set screw.
• Reattach the rear guide hose.

Accessories

Only the following RIDGID products have
WARNING
been designed to function with the K-60SP Drain Cleaning
Machine. Other accessories suitable for use with other
tools may become hazardous when used on the K-60SP.
To prevent serious injury, use only the recommended ac-
cessories.
Cable Selection Chart
Model Length Size/Type
C-7 7 1 / ' 5 /
2 8
C-8 7 1 / 5 /
'
2 8
C-9 10' 5 /
8
C-10 15' 7 /
8
1.800.561.8187
K-60SP Drain Cleaning Machine
1 / " hex key (Figure 9).
4
Typical Application
" (16mm) 2" & 3" Floor drains
" (16mm) Drain Lines 1 1 / " – 2".
4
Ideal for proper cleaning of small lines
" (16mm) Drain Lines 2" – 4".
Ideal for drains and stacks
" (22mm) Drain Lines 2" – 4". Roof-top vent stacks
www.
7 / " Cable and Leader
8
Catalog
No.
62275
30007
5 / " Cables
8
Catalog
No.
51317
62270
62265
Cable Kits and Tool Kit
Catalog
No.
61630
61625
48472
48477
Characteristics
Tight wind cable providing good rigidity in a hollow core cable. Not recommended for tree roots.
Open wind cable that is more flexible than C-7. Open wind acts as an auger to thoroughly remove
blockages in small lines.
Heavy-duty open wind cable ideal for long runs in indoor lines.
Standard all-purpose open wind. Excellent flexibility.
Ridge Tool Company
.com
Model
No. Description
C-10 15' All-Purpose Wind (4.6m)
T-127 / " Trap Leader
7
8
Model
No. Description
C-9 10' Heavy-Duty (3m)
C-8 7 1 / ' All-Purpose Wind (2.3m)
2
C-7 7 1 / ' Tight-Wind (2.3m)
2
Model
No. Description
A-62 Standard Equipment Cable Kit for
K-60SP-SE, includes:
– Five Sections C-10, 7 /
8
– A-8 Cable Carrier
A-61 Standard Equipment Tool Kit for K-60SP-SE
includes:
– T-101 Straight Auger
– T-102 Funnel Auger
– T-107 Spade Cutter
– T-125 Retrieving Auger
– T-150-1 Sharktooth Cutter
– A-3 Tool Box
– A-12 Pin Key
A-35 5 / " Cable Kit, includes:
8
– Six Sections C-8, 5 / " x 7
8
– A-10 Cable Carrier
– T-201 Straight Auger
– T-202 Bulb Auger
– T-205 "C" Cutter
– T-211 Spade Cutter
– A-13 Coupling Pin Key
A-35TW 5 / " Tight-Wind Cable Kit, substitutes C-7
8
for C-8 in above package
information@itm.com
"x15' Cable (75' , 23m)
1 / " Cable (45',14m)
2
9