Machine Storage; Service And Repairs - RIDGID K-60SP Manuel D'utilisation

K-60SP Drain Cleaning Machine
Figure 13 – Loosen Jam Nut
5. Install new belt and set unit down on bottom of frame
(operating position), so belt will become tensioned by
the weight of the motor.
6. Rotate the motor adjustment set screw until it just
touches the motor. Once the set screw touches
motor, rotate set screw
NOTE! Do not tighten this set screw by driving it into the
motor.
7. While holding the set screw in place with the
hex key, tighten the jam nut (Figure 14).
Figure 14 – Tighten Jam Nut
1.800.561.8187
12
1 / turn clockwise.
2
3 /
16
Ridge Tool Company
www.
8. Attach jaw housing to machine with socket head cap
screws.

Machine Storage

Motor-driven equipment must be kept in-
WARNING
doors or well covered in rainy weather. Store the machine
in a locked area that is out of reach of children and peo-
ple unfamiliar with drain cleaners. This machine can
cause serious injury in the hands of untrained users.
If machine has been exposed to freezing weather, unit
must be run for ten (10) to twenty (20) minutes without
load to warm up. Failing to do this will result in frozen bear-
ings. If machine is exposed to weather for a period of time,
moisture will form across motor windings causing motor to
burn out.
Service and Repair
The "Maintenance Instructions" will take care of most of
the service needs of this machine. Any problems not
addressed by this section should only be handled by an
authorized RIDGID service technician.
Tool should be taken to a RIDGID Independent Auth-
orized Service Center or returned to the factory. All repairs
"
made by Ridge service facilities are warranted against de-
fects in material and workmanship.
When servicing this machine, only iden-
WARNING
tical replacement parts should be used. Failure to follow
these instructions may create a risk of electrical shock or
other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
.com
WARNING
information@itm.com