Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DANGER:
•
To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions and
warning indications before using. This machine has been designed to be safe when it is used for its
specified purpose and in the specified manner. If damage to electrical or mechanical components
is found, the machine and/or the accessory must be repaired at the relative authorised service
centre or else at the manufacturer before use, in order to prevent further damage to the appliance
or physical injury to the user.
•
Before connecting the appliance to the electricity socket, make sure the electrical information on
the plate corresponds to that of the mains supply. The appliance must only be powered with
alternating current and voltage equal to that shown on the serial number plate.
•
The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
•
Before each use, check for any damage on the connection cable and on the power plug. If the cable
is damaged, immediately contact a specialist technician to restore it to normal functioning.
•
Connect the appliance only to an electrical connection installed by an electrical installer in conformity
with IEC 60364-1.
•
Never touch the power plug with wet hands.
•
Make sure that the cable to the mains or the extension cable have not been damaged by having
been walked on, crushed, pulled or the like. Protect the cable from heat and from contact with oils
or sharp edges.
•
Regularly check that the cable connecting to the mains is not damaged, for example with signs of
ageing or cracks. If there is damage, the cable must be replaced by a specialist TMB srl technician
or else by a technician with similar qualifications before using the appliance again.
•
Protection against splashes of water and the mechanical strength need to be ensured also after
any replacement of the joints of the power cable or the extension cable.
•
Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or other
electrical faults).
ATTENTION:
•
The procedure causes short-term reduction in voltage.
•
In unfavourable grid conditions the other appliances could be damaged.
•
This damage could occur if the grid impedance is less than 0.15Ω.
CONNECTION TO THE ELECTRICITY GRID
13
Publicité
Table des Matières
