Replacing The Batteries; Fixing The Strap; Cleaning And Disinfecting Routine; Maintenance - Lanaform PO-100 Mode D'emploi

12 Replacing the
batteries
Replace the batteries when low and when
the symbol flashes on the screen. Install
two AAA dry-cell batteries in the battery
compartment according to the polarity in-
dicated and replace the battery cover.

13 Fixing the strap

M-PO100-001.indd 8 M-PO100-001.indd 8
You can fix a strap to the device to make it
6 easier to carry the pulse oximeter. Slide the
thin end of the strap through the holder as
illustrated. Firmly pull the other end of the
strap through the holder of the narrow end.
14 Cleaning and
disinfecting routine
Cleaning
Turn off the instrument and remove the
batteries before cleaning. Make sure the
instrument looks clean, is free of dust and
dirt. Clean the instrument's outer surface
(including the OLED screen) with 75% med-
ical spirit and a piece of soft, dry cloth.
Make sure the liquid does not run into
7
the instrument when cleaning.
Do not immerse any part of the instru-
ment in any liquid.
Disinfection
Before measuring with the instrument,
clean the rubber pad with a piece of soft,
dry cloth soaked in 75% medical spirit.
Clean the finger to be measured with
medical spirit for the purposes of disin-
fection before and after use.
Warning
Do not disinfect the instrument by disin-
fecting at a high temperature/high pressure
or with gas.

15 Maintenance

• Remove the batteries from their cas-
ing and store them properly if you do
not intend to use the oximeter for a
lengthy period.
• Store the oximeter between 14°F and
122°F (–10°C to +50°C) and at levels
of humidity of between 10% and 93%.
• Check the oximeter regularly for damage.
• Do not use the oximeter in an envi-
ronment containing flammable gases
or use it in an environment where the
temperature or humidity is excessive-
ly high or low.
• Check the accuracy of the oxygen sat-
uration and pulse rate measurements
using an appropriate calibration device.
31/07/2020 16:16:21 31/07/2020 16:16:21