Adjusting its alarm
Hold the power button down for 1 second
while the oximeter is on. The configu-
ration interface 1 is displayed, as the
illustration shows.
Move "*" to the corresponding option by
continually pressing the power button.
Hold the power button down for 1 sec-
ond to activate/deactivate the alarm: when
ALM is activated and the measured val-
ues of the oxygen saturation of the blood
and pulse exceed the top or bottom lim-
it, the oximeter emits a sound alert. Hold
the power button down for 1 second to
M-PO100-001.indd 6
M-PO100-001.indd 6
activate/deactivate the beep: when the
beep is activated, a tick-tack will be
heard with the pulse beats when the pulse
rate is being measured. While the "*" re-
mains on the Restore option, hold down
the power button for 1 second to restore
the factory settings.
Brightness settings
Press the power button on the settings
1 interface to select the Brightness op-
tion, then hold the button down to adjust
the brightness on a value between 1 and
5. The higher the value, the higher the
screen's brightness.
Adjusting the alarm range
On settings interface 2 (hold the power
button down for 1 second when you are
in the settings 1 interface and the "*" sym-
bol is displayed on Alarm Setup), press the
power button to switch between options.
You can define the upper and lower lim-
its of the "
" oxygenation rate alarm
SpO
2
on this interface as well as the upper and
lower limits of the "PR" pulse rate alarm.
While the "*" symbol remains on option
+/-, hold the power button down for 1 sec-
ond to adjust the option to + or -. In + mode,
select the corresponding option and hold
the power button down to increase the up-
per or lower limit. In - mode, hold down
the power button to reduce the upper or
lower limit. Move "*" to the Leave option
and hold the power button down to return
to the monitoring interface.
09 Instructions for use
Insert a finger fully into the oximeter's
measuring sections. Keep the surface
of the nail pointing upwards and release
the clip. Press the power button to switch
on the oximeter.
31/07/2020 16:16:21
31/07/2020 16:16:21
4