Intercom Failure; Intercom Reconnection; Sx.com Configuration Setting - Nexx SX COM Mode D'emploi

intercom call. You will also hear a voice prompt saying "Intercom
requested". In this case, the intercom call does not override the
mobile phone call because intercom has lower priority than mobile
call. You have to hang up the mobile phone call to make or receive an
intercom call.

Intercom Failure

When you try to start an intercom conversation with an intercom friend
who is already having a mobile phone call with another person, you will
hear a low tone double beep signifying a busy signal. You will also hear a
voice prompt saying "Intercom failed, try again later". In this case, you
have to try again later. On the other hand, the intercom friend will hear
4 high tone beeps alerting them that there is an incoming intercom call.

Intercom Reconnection

If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom
will be disconnected. In this case, the SX.COM automatically tries to
reconnect the intercom every 8 seconds. You will hear high tone double
beeps until the intercom is reestablished. If you don't want to make a
reconnection, press and hold the (-) Button for 1 second to stop the
attempt.
7. SMH3 CONFIGURATION SETTING

7. SX.COM CONFIGURATION SETTING

You can set the configuration of the SX.COM by the voice menu
instruction as below.
1. To enter into voice configuration menu, press and hold the (+) Button
for 10 seconds until the LED shows solid blue and you hear high tone
double beeps. You will hear a voice prompt saying "Configuration
menu".
2. Press the (+) Button to navigate between menus. You will hear voice
prompts for each menu items as below.
3. You can enable or disable the feature or execute the command by
pressing the (-) Button.
4. If any button is not pressed within 10 seconds, the SX.COM will exit
the configuration and goes back to standby.
5. If you want to exit the configuration immediately, press and hold the
(+) Button until you hear a voice prompt, "Exit configuration", and
press the (-) Button.
SX.COM
17