Useful Advice - EdilKamin LAGUNA W 25 Installation, Usage Et Maintenance

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 82
After a few minutes, open the door and check if the wood is lighting properly
Ensure this condition.
Attention: switch on is not permitted in the absence of alarms.
IMPORTANT: when on, the lower door can never be opened.
The upper loading door must be opened only to check the wood storage and to load it.
At the time of opening, release the handle by opening it a few centimetres and wait a few seconds
before opening it completely, to ensure the fan reaches the maximum speed.
Only keep the door open for the time strictly necessary for wood loading.
Close the door tightly.
N.B. The loading door should never be left open during normal boiler operation, but only to carry
out the aforementioned operations.

USEFUL ADVICE

In daily management of the boiler, before proceeding with switch on, check each day that inside
the wood storage an excess quantity has not deposited of ash which can disturb good boiler op-
eration. In this case, you need to make the ash fall through the central opening with the help of a
tool.
Check the opening is always open before proceeding to switch on.
Open the lower door of the combustion chamber and remove the ash with the help of a pallet.
Only having carried out these simple, but important operations proceed to switch on.
AIR ADJUSTMENTS
Removing the panel (A), between the two doors, you can adjust the quantity of air for combustion,
based on the type of wood used, using the knobs (B) and (C).
If the wood has low humidity, simply adjust the knob (B), to the minimum or to the maximum (B) if
humidity is high.
INSTRUCTIONS FOR USE
adjust primary air
"B"
remove panel
"A"
adjust secondary
air "C"
- 70
-

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Laguna w 35

Table des Matières