F.F. Group BCS 40 PLUS Notice Originale page 70

70 | English
PROBLEM
Motor stops while
cutting
Motor does not run or
runs intermittently
Chain brake does not
engage
Chainsaw does not cut
properly
Low cut time per bat-
tery charge
ENGLISH
TROUBLESHOOTING
POSSIBLE CAUSE
Chain pinched in cut
Overheating of control
system
Battery discharged
Safety button not pressed
Battery pack not fully inserted
Battery contacts dirty
Battery pack cold
Overheating of motor
Debris in side cover
Defective power switch
Debris preventing full movement
of front hand guard
Possible chain brake malfunction
Insufficient chain tension
Dull chain
Chain installed backwards
Worn chain
Dry or excessively stretched chain
Chain not in bar groove
Dull chain
Worn chain
Dry chain
Over tensioned chain
Debris in side cover
Battery pack not fully charged
RECOMMENDED ACTIONS
Undercut limb to relieve pressure on limb.
Let the control system cool down
Charge the battery
Press the safety button before squeezing the trigger
switch
Press the battery pack into the battery port until it clicks
into place
Remove the battery pack, remove debris from the battery
port, and then clean the contacts with a clean, dry cloth
Allow the battery pack to warm to the minimum operating
temperature of 0°C.
Let the motor cool down
Remove battery pack, then remove side cover and clean
out debris
Contact authorized service center
Clean debris from external chain brake mechanism.
WARNING: Operating a chainsaw without a functioning
chain brake could lead to serious personal injury. Contact
an approved service location before using.
Tension the chain
Sharpen the chain
Install the chain with the teeth facing the correct direction
Replace the chain
Check the oil level. Refill oil reservoir if necessary
Reset chain onto groove
Replace the chain
Check the oil level. Refill oil reservoir if necessary
Tension the chain
Remove battery pack, then remove side cover and clean
out debris
Charge the battery
BCS 40/40V PLUS