GE GSD2204PWW Guide D'utilisation Et D'entretien page 21

PROBLEM
DISHWASHER WON'T RUN
UNUSUAL NOISE
DISHES DON'T DRY
UNCLEAN DISHES AND
FLATWARE
DETERGENT LEFT IN
DISPENSER CUPS
DETERGENT CUP LID WON'T
LATCH AFTER ADDING
DETERGENT
YELLOW OR BROWN FILM
QUESTIONS ? QUESTIONS ?
USE THIS PROBLEM SOLVER USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
A fuse in your home may be blown, or the circuit breaker tripped.
Replace a fuse or reset circuit breaker. Remove any other
appliances from the circuit.
Try pressing the START/RESET pad (Electronic models) two times.
In some installations, power to the dishwasher is provided through
a wall switch, often located next to the disposer switch. Make sure
it is on.
Utensils may not be secure on rack pins, or something small may
have dropped from the rack. Water is causing utensils to rattle.
Make sure everything is securely placed in dishwasher.
Motor hums. Dishwasher has not been used on a regular basis. If
you do not use your dishwasher often, set it to fill and pump out
once every week, this will help keep the seal moist.
Make sure inlet water temperature is correct.
(See How to Test Water Temperature section Page 8.)
Unload the bottom rack first. Water from dishes in the top rack
may be spilling into the bottom rack.
Check for improper loading. Dishes shouldn't nest together.
Avoid overloading.
Check the rinse agent dispenser to see that it's not empty.
Check inlet water temperature. It should be 49°C (120°F).
(To test, see How to Test Water Temperature section Page 8.)
Water pressure may be temporarily low. Turn on a faucet. Is water
coming out slower than usual?If so, wait until pressure is normal
before using your dishwasher.
Improper rack loading. (See Loading section Page 10.)
Rising Wash Tower blocked. (See Loading Section Page 11.)
Water may not be reaching the detergent cups. Move dishes that
may be blocking detergent cup.
The dispenser cover may not be opening or may be blocked by
improperly loaded items. If you used a powder detergent, open the
cup and remove any caked-on detergent. If the cup still doesn't
open automatically, call for service.
Detergent may be old. If the powder detergent is hard or caked in
the box, throw it away. The detergent may not be working well.
Cycle Indicator Dial must be OFF for cup lid to close and latch
properly. If you unlatch the door and open it to dry your dishes,
the Cycle Indicator Dial does not advance by itself.
An overall yellow or brown film on dishes or glassware can be
caused by iron deposits in water. A special filter in the water
supply line is the only way to correct this problem. Your water
softener company can tell you about the filter.
Yellow film on sterling silver results when you wash copper
utensils in the same load. Silver polish will usually remove this
stain.
21