Filling The Reservoir - Transcend 365 miniCPAP Guide Rapide

Transcend 365 miniCPAP Quick Guide
Caution! Use distilled water only. The use of distilled water is required for proper
function of the heated humidifier. Failure to use distilled water will damage the
humidifier and require repair or replacement. Alternatively, water may be filtered with the
Transcend Portable Water Filter for use with your Transcend 365 miniCPAP humidifier.
The ZeroWater™ Portable Filter Replacement Cartridge can be purchased directly from
your Transcend dealer, or at most major retailers.

Filling the Reservoir

1. To remove the reservoir from the CPAP, first disconnect the power source to your
CPAP, then set the device on a flat, stable surface and secure the reservoir with one
hand while you lift and remove the CPAP with your other hand. The pieces are
simply joined by magnets - there is not a button or latch that releases the
humidifier from the CPAP device.
2.
Hold the reservoir at a slight angle and fill it with distilled water only. This step is
best performed over a sink in case you spill water while filling the reservoir.
Caution: Do not perform this operation near electronic equipment. Always unplug
the power source to your CPAP before attempting to remove the reservoir.
Page 20