Princess 509201 Mode D'emploi page 7

Description (fig. A)
Your 509201 Princess hairdryer has been
designed for blow-drying your hair.
1. On/off switch
2. Temperature switch
3. Cool air function button
4. Handgrip
5. Airflow outlet
6. Air intake filter
7. Nozzle
8. Diffuser
Assembly
Warning! Before assembly, always switch off
the appliance and remove the mains plug from
the wall socket.
Mounting the accessories (fig. B)
The nozzle (7) focuses the airflow onto a small
area and smoothes out the hair for a sleeker
style. The diffuser (8) makes your hair appear
thicker and provides soft waves for a more
tousled look.
• Press the accessory onto the airflow outlet
(5) until it clicks into place.
Use
Warning!
• Do not use the appliance near bathtubs,
showers, basins or other vessels
containing water.
• If you use the appliance in a bathroom,
remove the mains plug from the wall
socket after use. The presence of water
can cause a risk of personal injury or
damage to the appliance even when the
appliance is switched off.
• For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA in the electrical circuit of the
bathroom. Contact your installer for advice.
Hints for optimum use
• If possible, allow your hair to partially dry
naturally. If it is necessary to use the
appliance, remove as much moisture from
your hair as possible.
• Use a wide-toothed comb to avoid damage
to the hair.
• Move the hot airflow in the direction of the
hair to avoid disturbing the cuticle.
• Do not use a brush until the hair has dried
sufficiently to avoid damage to the hair.
• Do not rub your hair with a towel to prevent
your hair from catching on the fibres,
stretching and snapping.
• First treat the lower sections of your hair
and slowly move the appliance to the
higher sections.
• If you use the appliance with the head
upside down, your hair will get more lift and
body.
• If styling is required or if you have curly
hair, make sure that your hair is a little
damp.
• If you have curly hair, use the diffuser to
spread the airflow and to make sure that
the curls are not straightened out.
• If you have fine hair, you must use a lower
temperature setting. If you have rough hair,
you can use a higher temperature setting.
• If you have a cowlick, wrap your hair firmly
around a brush in the opposite direction
and then blow-dry to smooth out the
cowlick.
Switching on and off (fig. C)
• To switch on the appliance, set the on/off
switch (1) to one of the following positions:
- For a lower blowing force, set the
on/off switch (1) to the 'I' position.
- For a higher blowing force, set the
on/off switch (1) to the 'II' position.
• To switch off the appliance, set the
on/off switch (1) to the 'O' position.
Setting the operating temperature
(fig. D)
• For a low temperature, set the temperature
switch (2) to the 'O' position.
• For a medium temperature, set the
temperature switch (2) to the 'I' position.
• For a high temperature, set the
temperature switch (2) to the 'II' position.
Using the cool air function (fig. E)
The cool air function makes sure that the
appliance temporarily provides a cooler airflow.
7