Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
This may significantly reduce the exposure level
over the total working period.
1st n
= Idle speed (1st gear)
0
2nd n
= Idle speed (2nd gear)
0
1st n
= Load speed (1st gear)
1
2nd n
= Load speed (2nd gear)
1
in rpm
Number of impacts n
Corner dimension in mm
Collar diameter in mm
Weight in kg
Drilling or percussion drilling in con-
crete - max. ø in mm
Drilling or percussion drilling in brick -
max. ø in mm
Drilling or percussion drilling in sand-
stone - max. ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
mm
Drilling in wood - max. ø in mm
Your power tool is double-insulated
in accordance with EN 60745; For
this reason an earth wire is not
required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and
is immune to disturbances in accordance with EN
55014-2
4. Operation
Putting into operation
-1
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
Additional handle
Place the additional handle 2 in the working posi-
tion to provide a safe and fatigue-free working sit-
uation.
Tighten the lower hand grip of the additional han-
dle 2 by turning in clockwise direction. Turn the
hand grip in anticlockwise direction to release it.
Depth setting
The required drilling depth X can be set by using
the depth stop 3.
Release the additional handle 2 and insert the
depth stop 3 into the additional handle.
Extend the depth stop 3 until the distance be-
tween the tip of the drill and the tip of the depth
stop 3 corresponds to the required drilling depth X.
Mains cable
Before carrying out any work on the
machine, pull the main plug.
Observe correct main voltage!
Fit the additional handle
Connect mains cable module if necessary
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
Operate the machine only with the ad-
ditional handle
Loss of control can lead to injury.
If the mains cable is damaged while
working, pull the mains plug immedi-
ately.
English 17
cables
specifically
SBM-EN/0802
EN
Publicité
Table des Matières
