Copyright Protection; Commissioning; Safety Information; Delivery Scope And Transport Inspection - CASO DESIGN Zitruspresse CP 200 Mode D'emploi

12.5 Copyright protection

This document is copyright protected. Braukmann GmbH reserves all the rights, including
those for photomechanical reproduction, duplication and distribution using special
processes (e.g. data processing, data carriers, data networks), even partially.
Subject to content and technical changes.

13 Commissioning

This chapter provides you with important safety notices during the initial commissioning of
the device. Observe the following notices to avoid dangers and damages:

13.1 Safety information

Warning
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.

13.2 Delivery scope and transport inspection

As a rule, the CP 200 / CP 300 is delivered with the following components:
 CP 200 / CP 300
 Juice tray
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

13.3 Unpacking

To unpack the device, proceed as follows:
 Remove the device out of the carton and remove the packaging material.

13.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled. Returning the packaging back to the
material loop saves raw materials and reduces the quantities of accumulated waste. Take
any packaging materials that are no longer required to "Green Dot" recycling collection
points for disposal.

13.5 Setup location requirements

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Place the device on a firm and even work surface.
 filter insert
 operation manual
 1 cone
24