Cleaning And Mainterance - TurhanCelik 630 Série Mode D'emploi



 After friying process has been completed, switch off the main switch. Then lift the basket up. Finally, place it onto the
well where there is a hole for basket hook. When the oil in the basket are filtered properly it can be served.
Turning off the appliance
 Turn the thermostat and switch control knob back to 0.
Draining off the water
 Place a heat-resistant container under the well.
 Open the drain cock.
 After draining close the drain cock.
 Do not wash the appliance with jets of water.
 Before cleaning the appliance, disconnect the electrical power supply.
 Make sure the water circuit is free of ferrous particles. Any such particles deposited in the bottom of the well may
cause it to rust.
 Do not use corrosive substances to clean the floor underneath the appliance.
 The appliance should be cleaned with a cloth wetted with warm soapy water when it's still warm.
 Do not use any abrasive detergents or materials such as wire brushes that may scrape the stainless steel surface of the
appliance.
 If the appliance can not be cleaned by above mentioned methods apply chemical solvents.
 If the appliance will not be operated for a long time, apply a thin layer of vaseline on the stainless steel surfaces of
the appliance.
 In case of noticing any failure at the appliance, call the authorized technical service. Do not allow any unexperienced
person to control the appliance.
CLEANING AND MAINTENANCE
13