Replacemont Of Spare Parts - TurhanCelik 630 Série Mode D'emploi

IMPORTANT : Before carrying out maintenance work or repairs, disconnect the appliance from the power supply at
the isolating switch.
Temperature t
 Remove the upper control panel.
 Open the appliance doors and drain the water from the well in question (see "Draining off the water").
 Detach the bulb from the thermostat fixed to the heating element by special support brackets.
 Disconnect the electrical connections.
 Replace the part.
Beware of the appliance's hot surfaces!
This appliance is designed for professional tise and must only be used by trainedpersonnel.
It is exclusively designed to fry food. Any other use is considered improper.
Never switch on the appliance without any oil.
 In the event of fault, disconnect the electric connection of the pasta cooker.
 Repairs should only be carried out by authorised service centres using original spare parts.
 The water in the well should be between the bottom and top level lines. If the water in the well is lower than the
bottom level line, add water.
 After installation and before the machine process, remove the protective industrial grease applied on the well and the
baskets. The following steps should be considered for the cleaning process:.
 Open the lover tap and discharge the water.
 The well should be rinsed with clean water properly.
 The remained particles and isolation materials on the equipment may cause some smoke and smell during the first
operation but will die down after a while.
 The appliance should be operated in maximum speed for one hour at first operation.
Filling the fryer well
 Close the well drain cock.
 Fill the well with water or blocks of lard to at least the minimum reference mark.
IMPORTANT : Never switch on the appliance without any water.
Turning on the appliance
 In this situation, yellow indicator will be on.
 To heat the fryer, turn the thermostat control knob to the required temperature setting. In this situation, yellow
indicator will be on. When the temperature reaches the required value white indicator will be off.
0 Off
0
50 C Minimum temperature
----- Intermediate temperatures
0
300 C Maximum temperature (approx.)
 When the oil reaches the required temperature, place the ingredient to be fried into the basket. The ingredient should
not exceed 3/2 of the basked.
REPLACEMENT OF SPARE PARTS
USE AND MAINTENANCE INSTRUCTIONS
WARNINGS
USE
12