Usage; Maintenance; Inspection - Invacare Softform Mode D'emploi

Softform-Mattresses
WARNING

The introduction of certain third party products between
the mattress surface and the user may reduce or impede the
clinical effectiveness of this product.
'Third party products' may include, but are not limited to
items including under blankets, plastic sheets and sheepskins,
etc. Heated over blankets must only be used in consultation
with a suitably qualified healthcare professional, as an increase
in temperature can increase the risk of developing pressure
ulcers.
3

Usage

▸ Remove all packaging before use.
▸ Place the Softform
mattress directly on the frame of the bed.
®
WARNING

It is very important for the patient to reposition themselves,
or to be repositioned, on a regular basis. This must be based
on the clinical judgement of a qualified healthcare professional.
This relieves pressure which helps prevent both tissue com-
pression and potential ulcer formation.
!
IMPORTANT
Medical equipment including infusion pumps and monitors
should be attached to appropriate bed accessories. In do-
mestic settings common causes of damage include cigarette
burns and the claws of pets that puncture covers, allowing
fluid ingress and staining.
6
!
IMPORTANT
To prevent accidental cover damage, do not place hypodermic
needles, venflons, scalpels or other similarly sharp objects
onto the mattress. Ensure that all venflons are taped down
correctly with no sharp edges exposed.
When using bridging boards or other patient transfer aids,
care should be taken not to damage the mattress cover. All
transfer aids should be checked for any sharp edges or burrs
before use as these can damage the mattress cover.
It is important to ensure that the mattresses are not jam-
med or damaged by sharp edges when used on beds with an
adjustable frame.
CAUTION

▸ The printed side of the mattress cover must always be
facing upwards.
▸ Make sure that the distance between the surface of the
mattress and the top of the side rail should be at least
220 mm.
4

Maintenance

4.1 Inspection

Check mattresses (foam and cover) for strike-through (this may include
fluid ingress, stains, rips or damage) after the release of each patient or
on a minimum monthly basis (depending on which occurs first) by a
suitably qualified and competent person.
Check mattresses
▸ Unzip the cover completely.
▸ Check for any staining on the white underside of the cover.
▸ Check for any staining on the interior foam.
▸ Replace any stained items and dispose of as per local authority
procedure.
Usage