WOLFF EXTRO 2-Stripper 230 V/ 50 Hz Traduction Du Mode D'emploi Original page 20

EN
► Coverings with a fleece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with
the fleece backing.
► Semi-flexible tiles:
Provided they are not extremely flexible, semiflexible -
tiles can be removed without pre-cutting them.
Attention
In general, no statements can be made on which
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
► With U-blades, the pre-cutting step in not necessary
for many flexible coverings, the coverings must be
checked on-site.If the tyre wear is highly visible on
the surface, the U-blade should not be used.
► We recommend using flat blades of varying lengths
and widths for flexible, elastic floor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
this case, the blade must be inserted with the blade
edge down.
► The heavy-duty special blades are generally suitable
for hard coverings, such as parquet or ceramic tiles.
10.0 Guarantee
The warranty period for new Wolff machines shall last for
one year from the point at which the machine is transfer-
red / delivered to the customer, insofar as statutory legal
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted. All repairs within the
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Customers performing their own repairs and/or improper
repairs regularly lead to the exclusion of warranty claims.
The same also applies to incorrect operation and/or use.
Replacement of parts, accessories and other modifica-
tions to Wolff machines
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
20
Important blade recommendation:
Users of Wolff machines enjoy a high level of safety and
reliability of their machine. In order to maintain this status
quo, your Wolff tool may not be modified from the condition
in which it is delivered without following the rules below.
These rules apply to both the replacement of parts and
equipping the machine with accessories as well as other
technical modifications.
 All work undertaken to your Wolff machine must
be undertaken exclusively by a workshop that
has suitably trained and experienced personnel at
its disposal, as well as the requisite work equip-
ment. We recommend using authorised service
Centre.
 In the event of planned replacement of parts, plan-
ned addition of accessories or other planned
technical modifications, an assessment must al-
ways be carried out by an authorised service
Centre or us, as manufacturer, before work is com-
menced.
 It is highly recommend that only safety-approved
Original Wolff replacement parts and Original Wolff
accessories are used, which have been approved
by us, as manufacturer. Replacement parts and
accessories can be obtained from your authorised
service Centre, which will also be able to undertake
professional installation on your behalf. Original
Wolff replacement parts and Original Wolff acces-
sories have been checked for safety and suitability
especially for Wolff machines.
We are unable to adequately assess the safety and
suitably of non-Original Wolff replacement parts.
 In order to preserve operational safety and to pre-
vent damage in the event of technical modificati-
ons, of whatsoever nature, our technical guidelines
must always be observed. We are also always
happy to hear from you should you have any other
questions about your
Please note that we cannot accept any liability for
damage, insofar as this is sustained as the result of
incorrect work undertaken or as the result of violation
of the rules stated above.
www.wolff-tools.de
Wolff machine.