Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
► The blades are sharpened by the floor pavement.
Therefore theblade only has to be changed if it is
twisted, collateral rounded or becomes worn.
► The driving wheels are subjected to wear. They have
to be changed after approximately 16 mm (0.6 inch)
of the surface has been worn away. Otherwise the
working angle of the striking apparatus will not be cor-
rect especially critical with cork or foam backed
carpets.
4.2 Start up
► Consider the mains power. The voltage of the
power supply has to be conform with the specifica-
tions of the type plate.
Attention
► The blade has to be mounted properly.
► Make a test run of min. 1minute.
► Do not use damaged blades.
► Damaged blades can burst and injure.
4.3 Switching on/off fig. G
► The EXTRO-STRIPPER is operated by using the
handle on top of the central control panel. The machine
is switched on using switch (1). She starts immediately.
► By pressing the emergency stop switch (3) in the event
of danger, the entire machine can be shut down.
By turning the switch, the emergency stop is reset.
► The machine is equipped with a zero-voltage switch.
It prevents accidental start-up after the power supply is
reconnected. If power is interrupted during operation,
the EXTRO-STRIPPER must be switched on again by
pressing key button (1). (zero-voltage safety switch)
4.4 Pull Back
The patented Pull Back system was developed to allow for
an easy pulling back of the Extro Stripper.
When you have reached a wall or another obstacle during
your work, simpy pull the handle to lift the driving wheels.
The machine comes to a standstill although the wheels
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
18
Check the machine before use:
continue to rotate.
If you pull the handle more powerfully, you can pull back
the machine to the place where the next lane is to be
stripped off.
If the handle is moved forward again, the driving wheels
reach the floor again and the machine moves forward.
When working, make sure the handle is pressed gently to
the front so that the small transportation rollers are lifted.
4.5 Locking the Pull Back system fig. A
For certain floors, it may be required to lock the Pull Back
system. Use the two screws in the lifting brackets. (20)
Unscrew the screws, press the handle to the front and
tighten the screws through the lifting brackets to the angled
clips.
If you pull the handle, the blade is lifted from the floor
immediately without stopping the drive.
5.0 Transport
To avoid injury dismount the blade while transporting the
machine. Pull out the plug from the mains.
5.1 Carrying belt
To carry the machine, the provided carrying belts will be
fixed at the 4 brackets (13) fig.A.
6.0 Maintenance
Maintenance and Cleaning
► Before any work on the machine itself, pull the mains
plug.
► For safe and proper working, always keep the machine
and ventilation slots clean.
The machine must then be sent to an after-sales
Service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken in
www.wolff-tools.de
Publicité
Table des Matières
