Spare Parts; Disposal Information - WOLFF EXTRO 2-Stripper 230 V/ 50 Hz Traduction Du Mode D'emploi Original

manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools. In all correspondence and spare
parts orders, please always include the machine num-
ber specified on the type plate of the machine.
6.1 Lubrication of the Impact fig. F
The EXTRO-Stripper is virtually maintenance-free. Have
the guides of the swing bolts lubricated from time to time
(after approx. 500 square meters). The lubricator nipples
are located collateral on the front side.
The used grease will flush dirt out of the machine.
Press maximum 3 to 4 times with the grease gun. Never
press too much grease into the machine. Otherwise the
mechanism will be blocked.
6.2 Changing the driving wheels fig. B
Remove the splint-pins (4) and pull the wheels (3) from
the axle (1). Do not loose the keyes (2) under any circums-
tances!

6.3 Spare parts

Spare parts can be found on the internet at:
http://webkatalog.wolff-tools.com
7.0 Trouble shooting
Fault Possible cause
The machine Power supply
does not start interrupted
Defective cable
Defective plug
Higher exer- Cutting blade
tion of force dull
required while
working

8.0 Disposal information

Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
Only for EC countries:
usable must be collected separately and disposed of in an
environmentally correct manner.
Subject to change without notice
9.0 Notes on various floor cover-
ings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The EXTRO- STRIPPER is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched floor cover-
ing and carpeted flooring.
Hardwood parquet, multi-layer parquet, semiflexi-
ble and ceramic tiles can also be removed to a
limited extent.
► Needle-punched floor covering, carpet, PVC.....
Remedy
The coverings to be removed should be pre-cut in
blade-widths (fig. E) and then removed with the
Contact
stripper in one step. In many cases, the glue can
Electrician
also be removed at the same time.
For repair and
/or replace parts
► Coverings without a foam backing:
Replace Prior to performing the stripping work, pre-cut the
strips in blade-widths (fig. E). Regularly check
cutting blade
whether the blade is still straight and sharp.
or resharpen
► Coverings with a foam backing:
Only use sharp blades! Remove the large sections
of the wearing surface. Use a carpet pulling claw for
this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from
the side.
www.wolff-tools.de
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Elect-
ronic Equipment and its implementation into
national right, power tools that are no longer
EN
19