Putting Into Operation - Petra electric M 20.07 Mode D'emploi

• This appliance is not meant to be used by persons
(including children) with reduced physical, sensorial or
mental capacities or in absence of the necessary
experience and/or knowledge - unless they are
supervised by a person responsible for their safety and
from whom they get instructions on how to use the
appliance.
• Keep out of reach from children.
• If the following happens do not use the appliance and
unplug it immediately:
- the appliance or the mains cable is damaged
- any defect after the appliance has accidently dropped
or something similar is suspected.
In these cases have the appliance repaired.
• Disconnect the appliance in these situations:
- any malfunction during operation
- prior to cleaning and maintenance
- after use
• Do not immerse the appliance in water.
• In the case of misuse, wrong handling or incorrect repair
no liability will be taken for possible damages.
Claims under guarantee are also excluded in such cases.
• The appliance is not designed for commercial
purposes.
• In case the cord of this appliance is damaged, it has to
be replaced by an authorised service agent of the
manufacturer or a person having similar qualifications.
Substantial dangers for the user can appear from
inappropriate repairs.
Grinding degree
You can adjust the desired
grinding degree on the
regulation wheel (3) without
settings, from 1...6 –
espresso up to 17 – coarse
coffee powder. The
adjustment should be done
prior to filling of the coffee
beans, otherwise the beans
jamming between the
grinding discs might block the
motor. During the grinding procedure, the adjustment
can be changed at every time.

Putting into operation

Clean the lid (1) and the receptacle (2) for the ground
material before first use and dry it well. Put the plug into
the socket. Then fill the storing container and put the lid on.
Attention! This coffee grinder is exclusively suitable for
grinding coffee beans. The use of other grinding stock, for
example poppy seed, nuts, sugar, etc., is considered to
be improper and causes the loss of your warranty claims.
Adjust the desired number of portions by the regulation
wheel for the pre-selection (4).The grinding procedure
starts after turning the start button (5). In order to
exclude the danger of injuries on the rotating grinding
discs, a security sensor avoids that the motor starts
when the receptacle is not put on properly.
As soon as the adjusted quantity is ground, the coffee
mill switches off automatically. After the motor has
5