Charging The Battery Using The Battery Clamps - NORAUTO PREMIUM HF 1500 Mode D'emploi

INSTALLATION
D. Charging the battery using the
battery clamps .
When the charger is properly connected
to the battery and the charger is plugged
in to a functioning ac mains socket, the
charger will be in Standby mode and the
LCD screen will display the following (The
lower digital display shows the voltage of
the connected battery. The Clamp Icons,
Arrow Icons and the Battery Icon will light
solid.), indicating the unit is ready to use:
Note:
If the charger's battery clamps have a
bad connection or are disconnected to
the battery, the LCD screen will display
the following (The Clamp Icons will
flash and the empty Battery Icon will
light solid.), indicating the battery
clamps are not yet connected to the
battery:
If the charger's battery clamps are
connected incorrectly with regard to
polarity, the LCD screen will show the
following (The Fault Icon and "+" and
"–" inside the Battery Icon will flash.
The Clamp Icons and the empty
Battery Icon will light solid) and a
Warning will continuously sound until
the clamps are disconnected:
Disconnect the charger's ac plug from the
ac mains socket; then disconnect the
clamps. Reconnect the clamps with
correct polarity and plug the charger back
in at the ac mains socket.
1. When the charger is properly
connected, cycle through to
choose the following operation
mode by pressing the Mode
Selector Button
Moto 2A Charging Mode (Press once):
In this mode, the unit charges the battery
at a lower rate of charge with the
maximum current output to approximately
2A and the LCD screen will display the
following (The upper digital display will
blink "2.0A" and the Motorcycle Icon
will flash. The lower digital display shows
the voltage of the connected battery. The
Clamp Icons, Arrow Icons and the Battery
Icon will light solid) :
Vehicle 6A Charging Mode (Press
twice): In this mode, the unit charges the
battery at a higher rate of charge with the
maximum current output to approximately
6A and the LCD screen will display the
following (The upper digital display will
blink "6.0A" and the Vehicle Icon
will flash. The lower digital display shows
the voltage of the connected battery. The
Clamp Icons, Arrow Icons and the Battery
Icon will light solid):
129