Fein AGSZ18-280BL Mode D'emploi page 18

OBJ_BUCH-0000000289-001.book Page 18 Wednesday, November 22, 2017 8:24 AM
en
18
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 7).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start lock prevents the cordless
straight grinder from automatically restarting
again after a power interruption, e.g., after
changing the battery. In this case, switch the
power tool off, remove it from the workpiece
and check the application tool. Afterwards,
switch the power tool on again.
Use a collet that fits the grinding accessory.
Insert the clamping shaft of the grinding acces-
sory to the stop into the collet.
Observe the maximum permitted projecting
shaft length (a) of the grinding accessory
according to the manufacturer's instructions.
(see page 20)
Move the power tool back and forth applying
uniform pressure, so that the workpiece sur-
face does not become too hot.
Switching on:
Press and push the On/Off switch forward (I).
Switching off:
Press the switch downward ().
Fig. 7
On/Off switch
2.
1.