emerio TF-107809.2 Mode D'emploi page 5

PARTS DESCRIPTION
1. LED display
2. Air oulet
3. Control panel
4. Air inlet
5. Filter cover
6. Air filter
7. Power cord
8. Base
9. Remote control
OPERATION
1. Plug the power cord into a suitable
socket. The appliance is on standby
and the LED display is on showing
the current room temperature.
2. Touch the power icon "
3. Touch the icons on the control panel to choose your desired functions.
4. After use, touch the power icon "
Notice! This unit has a remote control. One piece of CR2032 battery will be provided with the unit. The functions
of the remote control buttons are the same as of the icons on the control panel.
*Please check below table for details.
Remote control Control panel
- 4 -
" on the control panel to start the fan. The appliance begins to work at low speed.
" again and unplug the appliance.
Touch this icon to activate the oscillation function. "
the control panel. Press this icon again, the oscillation function is off.
Touch this icon to choose natural wind "
sleeping wind "
working under normal wind (constant wind and no symbol will illuminate in
the control panel.).
Touch this icon to set timer from 0.5 to 7.5 hours. By default, it is 0.5h per
setting. You can also touch and hold icon for 3 seconds, and then time will
be increased 1h per setting.
The set time will be flicking for 5 seconds and then fixed on the LED display.
Approximately 10 seconds later, the LED display will show back the current
room temperature added with timer icon " ". Then the timer will count
backwards by 0.5h. During operation, you can touch icon "
remaining time on LED display.
Touch this icon to choose your desired speed:
Low " ", Medium "
Touch this icon to turn on / off the appliance.
Function
" (soft wind, surging and receding). By default, the fan is
" and High " ".
" will be shown on
" (surging and receding) or
" to check the
TF-107809.2