Operation Control; Introduction To Users; Transformation To Operate With Other Gas Type - Diamond G77/PL4T Manuel D'instructions

2.6.5

OPERATION CONTROL

- Start the unit in accordance with the use instructions.
- Make sure there are no leaks following the local procedures.
- Check the ignition and interignition of the pilot burner and the main burner.
- Make sure the flue gases are discharged regularly.
- Write on a sticker, to be glued to the unit label, for what gas and pressure the unit has been calibrated
2.7

INTRODUCTION TO USERS

Explain the operation and use of the Griddle Plate to its user by consulting the manual, and illustrate any changes.
Leave the manual in the user's hands and explain that he/she should use in for further reference.
3.

TRANSFORMATION TO OPERATE WITH OTHER GAS TYPE

Remove the grease well (18 Fig. 6) Remove the knob (20 Fig. 6), the screws (17 Fig. 6).
If necessary, remove the plate, paying attention to the bulb.
REPLACING THE PILOT BURNER NOZZLE
N.B.: In order not to break the spark plug, it is advisable to first remove it (9 and 10 Fig. 4).
To change the pilot injector, you should unscrew the nut (7 Fig. 4) with a size-10 spanner and replace the injector (6 Fig. 4)
with one corresponding to the gas type chosen and shown on Table II.
REPLACING THE BURNER NOZZLE
Replace the burner nozzle (1 Fig. 3) with one corresponding to the gas type chosen and indicated on Table II.
Ignite the pilot burner (5 Fig. 3) by turning the knob (Fig. 7) to position (
knob to position 8, loosen the screw (2 Fig. 3) and adjust the flame by operating the regulation collet (3 Fig. 3), for each gas
type regulate the primary air (R.o.A.) of X mm (see injector Table II).
REPLACING THE IDLE BYPASS SCREW
Replace the idle screw (11 Fig. 5) located on the thermostat, with one corresponding to the gas type chosen, and complying
with injector Table II. Screw the idle screw or bypass all the way down.
After replacing the nozzles, apply on the existing label the one supplied with the machine indicating the new type of gas.
), ignite the burner (4 Fig. 3) by turning the
- 15 -
GB