Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 Operating
GB
4.4
Starting
application
42
Make sure that the skin areas to be treated are shaved, dry, clean and
free of creams, deodorants etc. Proceed as follows:
1.
Carry out steps 1 and 2 from chapter 4.2 "Skin test".
2.
Set the intensity that you have tested and which is suitable for your
skin, by pressing the ON/OFF button
long, until the desired intensity (Level 1 to 5) is lit on the intensity dis-
play
.
2
3.
Place the light area
trigger a light pulse. The skin contact area
(the readiness indicator
can be emitted by the device. When the pulse is emitted, you will see
a bright flash and may hear a clicking sound.
4.
Now place the device on another area of the skin while it charges for
the next light pulse.
5.
Then emit a new light pulse on the other skin area.
6.
Repeat this procedure for other planned skin areas.
7.
Switch the device off by pressing and holding the ON/OFF button
WARNING
•
Never emit several light pulses in succession onto the same
area of skin!
•
If pain, swelling or other unusual reactions occur during the
application, immediately stop the test and do not carry on
using the device. Contact your doctor.
onto the skin and press the trigger button
6
starts to flash green), so that a light pulse
3
briefly in succession so
1
must lie fully on the skin
7
to
8
.
1
Publicité
Table des Matières
