Publicité
Les langues disponibles
Les langues disponibles
Remove factory crossbars.
Prepare Catch Mount.
1034492D-2/12
• Driver Side Rear & Passenger Side Front: Lift tab to release
crossbar. reference your owner's manual for more information.
• Passenger Side Rear & Driver Side Front: Use the six lobe
wrench to remove the factory crossbars by turning the
fastener counter-clockwise.
• store fasteners and factory crossbars in a safe place.
DO NOT DRIVE VEHICLE WITHOUT EITHER FACTORY
CROSSBARS OR YAKIMA LANDING PADS INSTALLED.
• Using the hex
wrench fully open
both Catch Mounts
by turning the screw
counter-clockwise.
For Outback 2010 - 2012 proceed to page 3.
For Outback 2013+ proceed to page 4.
Publicité
