Publicité
Les langues disponibles
Les langues disponibles
2013-2014 OUTBACK
Install Landing Pads.
A
• Using the hex wrench install each Catch Mount and pad as pictured (Catch Mounts are located diagonally from one another). Fully tighten.
B
• Using the hex wrench install the M6 fastener, washer, Bare Mount, and pad as pictured.
C
• Using the hex wrench install m8 fastener, M8 washer, bare mount and pad as shown. To prevent screws from cross-threading start threading
fastener using your fingers. Fully tighten.
CATCH MOUNT
RECOMMEND
INSTALLATION
TORqUE: 20
IN-LBS
ATTACHMENT
HARDWARE CAN
LOOSEN OVER TIME.
CHECK AND TIGHTEN
AS NECESSARY,
BEFORE EACH USE.
1034492D-4/12
C
A
• Use covers whenever skyLine or Control Towers are not installed.
• store covers in safe place whenever skyLine or Control Towers are installed.
• Periodically remove landing pad and clean under pad.
• Periodically inspect pad for wear or cracking. replace if damaged.
Continue with SkyLine or Control Tower installation.
A
B
2013 + BARE MOUNT
RECOMMEND
INSTALLATION
TORqUE: 20
IN-LBS
Publicité
