Canon imageRUNNER ADVANCE C5255 Guide De L'utilisateur page 54

User's Guide: imageRUNNER ADVANCE (iRA) C5235, iRA C5235i, iRA C5240, iRA C5240i, iRA C5250, iRA C5250i,
iRA C5255, iRA C5255i - Edition 2012-04
2
Adjust the position of the paper drawer
guides.
1
2
1. Slide the left guide while squeezing it on the top to
align it with the mark for the desired paper size.
2. Slide the front guide while squeezing it on the top to
align it with the mark for the desired paper size.
Slide the guides until they click into place. If the left guide
and front guide are not aligned correctly, the paper size
will not correctly appear on the touch panel display. It
is also necessary to adjust the guides correctly to avoid
causing a paper jam, dirty prints, or making the inside of
the machine dirty.
3
Load the appropriate size paper into the
paper drawer.
1. Make sure that the paper size setting of the paper
drawer matches the size of the paper to load in the
paper drawer.
2. Load the paper stack against the right wall of the paper
drawer.
52 Routine Maintenance
2
1, 2
4
Change the paper drawer's paper size plate
to match the new paper size.
1
3
1. Open the inside cover of the paper drawer, and lift up
the plate.
2. Rotate the plate so that the new paper size is on the
right side of the plate.
3. Insert the plate straight down, and close the inside
cover.
The paper size that cannot be used depending on the
model and settings is also listed on the paper size plate.
5
Gently push the paper drawer back into
the machine until it clicks into place in the
closed position.
When returning the paper drawer to its original
position, be careful not to get your fi ngers caught, as
this may result in personal injury.
Only A4 transparencies can be used. Make sure that the
left guide is set to 'A4' when loading transparencies in a
paper drawer. If transparencies of a diff erent size (other
than A4) are loaded in a paper drawer, the paper size and
remaining amount of paper will not be detected correctly.
2
3