Operating Buttons - Abus CO2WM110 Manuel D'utilisation

Installation, Operating buttons and display symbols
Stand mounting:
• fold out the table base on the underside of the housing and place the detector on
a flat and dust-free surface
• ensure that the detector is stable and that no objects interfere with the
penetration of CO

Operating buttons

1. Switch on/off with a long press (approx. 3 seconds)
2. Mute
3. Switch on display with a short press
4. In setup mode: Move one position to the right
5. In setup mode: Increase value(s) by one
6. In the normal state: Change pages
1. Enter the setup mode by pressing and holding (approx. 3 seconds)
2. Switch the display off/on by pressing briefly
3. Save and exit settings by pressing briefly
4. Mute
1. In setup mode: Move one position to the left
2. In setup mode: Decrease value by one
3. In the normal state: Change pages
4. Switch on display with a short press
5. Mute
Kohlendioxidmelder_CO2WM110_Manual_1.indd 20 Kohlendioxidmelder_CO2WM110_Manual_1.indd 20
into the detector
2
– 20 –
19.02.2021 15:13:55 19.02.2021 15:13:55