Abus CO2WM110 Manuel D'utilisation page 19

5. Keep water and other liquids away from the detector as it is not waterproof
6. Do not insert sharp, flammable or metallic objects into the air inlets as this can
result in an electric shock or burns
7. Power should be supplied via the micro-USB cable and the AC adapter; the
internal, built-in battery is only used for emergency power supply
8. The detector can be mounted on the wall or set up with the table base
9. If the device has been dropped or otherwise damaged, it may not be used
anymore
10. The device must not be opened or repaired. Failure to comply will invalidate the
warranty
Wall installation:
• mark the drill holes horizontally with the enclosed
template and a spirit level
• drill the holes with a ø 5 mm drill bit
Important: do not damage any cables when drilling
and keep the detector away from drilling dust!
• push the plastic dowels into the drilled holes and
screw in the screws until the screw heads
protrude approx. 5 mm
Kohlendioxidmelder_CO2WM110_Manual_1.indd 19 Kohlendioxidmelder_CO2WM110_Manual_1.indd 19
68 mm
– 19 –
Installation
GB
ø 5 mm
19.02.2021 15:13:54 19.02.2021 15:13:54