Intended use, Start-up
Intended use
Only use the device for the purpose for which it was built and designed. Any other
use is not considered to be the intended use!
This device may only be used for the following purpose:
· Measuring carbon dioxide content, temperature and humidity in privately used
indoor spaces.
Poor indoor air is considered unhealthy. It can cause drowsiness, lack of
concentration and illness.
Reference values for carbon dioxide
250-350 ppm:
600 ppm:
600-1000 ppm: high air quality impairment
1000 ppm:
1.000 ppm should be the upper limit for the CO
Start-up
Before using the detector for the first time, please read the following instructions
carefully and observe all warnings, even if you are familiar with the use of
electronic devices.
1. Store and operate the detector in a dry place out of direct sunlight to protect the
components inside the detector
2. Before using the carbon dioxide detector for the first time, set it up in a
well-ventilated environment
3. In order to maintain the best performance of your detector, please use it for at
least 24 hours of permanent operation
4. Do not cover the detector and in particular do not block the air inlets while the
detector is active
Kohlendioxidmelder_CO2WM110_Manual_1.indd 18
Kohlendioxidmelder_CO2WM110_Manual_1.indd 18
normal ambient outdoor concentrations
minimum air quality impairment
indicates insufficient ventilation;
complaints such as headaches, fatigue or irritation of the eyes and
throat can occur.
concentration in the room.
2
– 18 –
19.02.2021 15:13:54
19.02.2021 15:13:54