Mount The Smoke Cabinet To The Grill Barrel; Securing The Chimney Stack - Louisiana Grills LGCAB 61299 Mode D'emploi

3. MOUNT THE SMOKE CABINET TO THE GRILL BARREL

Parts Required:
1 x Louisiana Grills Smoker (not included)
1 x Smoke Cabinet (#9)
Screw ( #A)
2 x
Washer ( #B)
2 x
Installation:
• Prepare the Smoke Cabinet to be mounted to the grill barrel of the
Louisiana Grills Smoker. Position the barrel end of the grill next to the
Smoke Cabinet, both front facing.
IMPORTANT: Once positioned, lock the caster wheels on the cart of the
grill, so that it does not move when mounting the Smoke Cabinet.
• Locate where the mounting bracket will latch onto the side end of
the grill barrel. Using a second person, lift the Smoke Cabinet up
and carefully lower the mounting bracket onto the side of the grill
barrel. Push down on the Smoke Cabinet firmly to ensure the bracket
is latched well. Release holding the Smoke Cabinet once the grill is
supporting it completely. Note 3A.
• Next, use two washers and screws to affix the spacer bar to the
support legs of the grill. This gives additional brace support to the
Smoke Cabinet. Note 3B.
IMPORTANT: If screw holes do not align, loosen the screws on the
spacer bar and mounting bracket more until all the hardware aligns
correctly, then secure all completely.

4. SECURING THE CHIMNEY STACK

Parts Required:
2 x Chimney Gasket (#1)
Chimney (#2)
1 x
Screw ( #A)
4 x
4 x Washer ( #B)
Installation:
• First, remove the chimney cover plate and screws from the end of the
grill barrel (comes with unit) to expose the chimney opening. Next,
remove the preinstalled screws from the top of the Smoke Cabinet.
• Prepare to install the chimney by placing one chimney gasket on each
end. From the outside of the grill barrel, hand-tighten the chimney
and chimney gasket to the grill barrel end using one screw. Next,
connect the chimney and chimney gasket to the Smoke Cabinet top
using one screw. Continue to add another screw, one on each side,
until there are four on each end. Note illustration 4A.
NOTE: Screws and washers are supplied as extra hardware, if needed.
• Once all eight screws are mounted, tighten completely. Ensure chimney
damper can move freely once chimney is secure. Note illustration 4B.
NOTE: Adjust the chimney damper to control the airflow into the Smoke
Cabinet. If smoking at low temperatures, keep the cap more open to
encourage more airflow movement from the grill barrel to the chimney.
6
3A
3B
4A
4B
CHIMNEY
DAMPER