Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D
abnormal use, and before, during and after important
GB
measurements.
F
Make sure the Stabila LD 400 optic is kept clean and
I
that there is no mechanical damage to the bumpers.
E
CAUTION:
In using the instrument for distance measure-
NL
ments or for positioning moving objects (e.g. cranes,
P
building equipment, platforms, etc.) unforeseen
N
events may cause erroneous measurements.
FIN
Precautions:
Only use this product as a measuring sensor, not as
DK
a control device. Your system must be configured and
S
operated in such a way, that in case of an erroneous
TK
measurement, malfunction of the device or power
failure due to installed safety measures (e.g. safety
CZ
limit switch), it is assured that no damage will occur.
SK
PL
Switching on/off
SLO
1x briefly: the instrument and the laser are swit-
HR
ched on.
H
The display shows the battery symbol
the next button is pressed.
RO
GR
Pressing this button for longer switches the
instrument off.
RUS
LV
The instrument switches off automatically after
three minutes of inactivity.
EST
LT
J
Operation
KOR
Setting the instrument
Press long until the desired unit is displayed.
Possible units:
Distance
1.
0.000 m
1
2.
0'0''
/
1
3.
0 in
/
16
4.
0.00 ft
CLEAR-Key
1x briefly: the last action is cancelled.
Illumination
1x briefly: the display illumination is switched on
or off.
Reference Setting
Default reference setting is from the rear of the
until
instrument.
The instrument can be set for the following measure-
ments:
•
To measure from an edge (see drawing {D}), fold
out the stop bracket until it snaps in for the first
time. See drawing {E}.
•
To measure out of a corner (see drawing {D}),
fold out the stop bracket until it snaps in, push
4
Area
0.000 m²
0.00 ft²
16
0.00 ft²
0.00 ft²
Volume
0.000 m³
0.00 ft³
0.00 ft³
0.00 ft³
Stabila LD 400
Publicité
Table des Matières
