Maintenance - SPARKY HeavyDuty BPR 261E Notice Originale

The optimum capacity when drilling in concrete
is up to 16 mm, and the possible capacity is up
to 26 mm.
The rotary hammer is suitable for light-duty chis-
elling. Higher durability and efficiency can be
achieved only when using sharp chisels.
ACCESSORIES
▪ Drill bits for metal Ø3 to Ø13 mm
▪ Drill bits for wood Ø3 to Ø30 mm
▪ SDS plus drill bits for concrete Ø3 to
Ø26 mm
▪ SDS+ core cutters up to Ø65 mm
▪ SDS+ pointed chisels up to 250 mm long
▪ SDS+ chisels up to 40 mm wide
▪ SDS+ grooving chisels up to 22 mm wide
▪ Screwdriver bits with 6,35 mm (1/4") hexagon
shaft
WARNING: We recommend using
these accessories or attachments when op-
erating your power tool. The use of any other
accessories or attachments might present a
risk of injury. Only use accessory or attach-
ment for its stated purpose. If you need any
assistance for more details regarding these
accessories, ask your local SPARKY service
centre.

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
Original instructions
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
9
EN