Troubleshooting Guide - Madison MAD-TA20BT Manuel D'utilisation

Systeme audio vintage a tubes 2 x 40w
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Notes:
If pairing fails the first time, turn off your system and back on. Then follow the
procedure from the beginning of this section.
If you are unable to reconnect to a previously connected device, remove or erase the
MAD-TA20BT from the list of paired devices from your smartphone and follow the
instructions of 'Pairing a new device'.
PROBLEM
Remote Control :
Remote Control not
working
CD Player Section :
No Sound
Skipping sound or
track
FM Radio :
Not receiving
stations
Not receiving the
©Copyright LOTRONIC 2015

Troubleshooting Guide :

POSSIBLE CAUSE
Batteries are exhausted
The remote control is
too far away from the
main system,
controlling angle is too
large, or there is an
obstacle in between.
There is no disc.
The disc is not loaded
with the printed side
up.
It is in pause mode.
The disc is dirty or
scratched.
The disc is dirty or
scratched.
The antenna is
disconnected.
The broadcast
frequency is not set
properly
An incorrect station
MAD-TA20BT
REMEDY
Replace with new
batteries
Operate the remote
within the recommended
operative range.
Load a disc.
Load it with the printed
side up.
Cancel the pause mode.
Clean it or load another
disc.
Clean it or load another disc.
Connect the antenna.
Set the broadcast
frequency properly
Memorize the correct
15

Publicité

Table des Matières
loading

Table des Matières