Descaling; Suitable Descaling Solutions - F.Bertazzoni F45CONVAPX Mode D'emploi

Care and maintenance

Descaling

Whenever steam is produced, irrespective of the
hardness of the local water supply (i.e. the
limescale content of the water), limescale is
deposited inside the steam generator.
The time interval between descaling depends on
the hardness of the water and frequency of use. If
steaming 4×30 minutes per week, the appliance
must be descaled (depending on water hardness)
roughly as follows:
Water hardness
Very soft
Medium
Very hard
The appliance automatically
descaling is necessary and when this happens
the Descale light stays on. If the Descaling
procedure is not performed, some cooking cycles
after the Descale light starts to flash. If once again
the Descaling procedure is not performed, some
cooking cycles after the oven functioning is
blocked, the Descale light stays on and the
display shows "CAL" blinking.
IMPORTANT NOTE: Failure to descale the
appliance will likely impair the functioning of
or cause damage to the appliance.
Descale after about
18 months
9 months
6 months
detects when

Suitable descaling solutions

For descaling, use the descaling solution "durgol".
This solution allows a professional and careful
descaling of your
Customer Care Centres.
Warning! Do not use vinegar or vinegar-based
products as they can cause damage to the
oven's internal circuit.
Traditional descaling solutions are not appropriate
because they can contain foaming agents.
appliance. Available
EN
at
22