Function: Infrared Tv Remote Control; Storing The Tv Programming Code; Learning Through Infrared Rays From Tv Control To Your Cordless - BRONDI DC6010TR Mode D'emploi

8. F
UNCTION: INFRARED TV REMOTE CONTROL
Your cordless features an infra-red ray door (on the top side) that allows to use it as an infra-
red remote control.
To use this function, confi gure fi rst of all your cordless. You have 2 possibilities:
• Make a programming on the cordless, that allows to store the code of the TV model you
want to control from your cordless.
• Perform the learning procedure through infra-red rays from the TV remote control to your
cordless.
The package of your cordless contains a list of the main commercial trade marks, with
the corresponding programming codes (4 fi gures). For each trade mark, each 4 fi gures
code corresponds to a given model. Following the procedure described hereafter, you must
program on your cordless the fi rst code corresponding to the TV trade mark, and then check
if your cordless controls your TV with this code. If this does not occur, repeat the procedure,
program the second code of the mark and check again the function of the cordless as a
remote control, and so on.
If none of the codes of that trade mark is valid, then proceed with the learning by means of
infra-red rays, as described in the following serction.
Storing procedure (on your cordless):
1. Press the button MENU.
2. Press once the button CH+ and then
".
Control
3. Press to select "
4. The display shows "
you will hear a confi rmation beep.
5. Press the button
Now enter the TV mode (press the red button TV) and try to use the controls (see par. "7.3
REMOTE CONTROL MODE: TV CONTROLS"). If the inserted code does not allow the use of the
TV functions, repeat the procedure inserting other codes of the same trade mark.

8.2 LEARNING THROUGH INFRARED RAYS FROM TV CONTROL TO YOUR CORDLESS

With this procedure, the cordless learns each single command of the TV remote control.
• Switching on/off of TV (on the cordless: button
• Channel UP (on the cordless: button CH+)
• Channel DOWN (on the cordless: button CH-)
• Volume UP (on the cordless: button VOL+)
• Volume DOWN (on the cordless: button VOL-)
• MUTE (on the cordless: button
• Selection of channels (on the cordless: buttons 0 to 9)
Learning can occur from the remote control of any commercial TV trade mark, if the control
operates with IR.
Before operating, fi nd the IR door on the cordless as well as on the TYV remote control, and
position them in such a way that the 2 doors face each other at a distance of ab. 2 meters.
CAUTION: During the learning procedure, it is important that you hold both devices (cordless
and TV remote control) motionless. Position them both in a steady way onto a table, at a
distance of 2cm.
Learning procedure:
1. On your cordless:
a. Press the button MENU.
b. Press once the button CH+ and then
".
Control
c. Press once the button CH- and then
d. The display shows "
e. On your cordless press the button corresponding to a command, f.ex. button CH+
(channel up).
2. On the TV remote control: press and hold pressed the button corresponding to the control
(ex. CHANNEL UP).
DC6010TR-lingue

8.1 STORING THE TV PROGRAMMING CODE

to enter the programming "
1. Code TV ".
". Dial the 4 fi gures of your TV trade mark, and press
Ins. code
to leave the programming and tor eturn to stand-by.
)
to select "
".
Press Button
19
19
)
to enter the Programming "
2. Learn ".
28-10-2005, 14:14
8. Remote
;
8. Remote