Using The "Phone" Function; Answering A Call; Make A Call With Manual Selection; Conversation With Speaker - BRONDI DC6010TR Mode D'emploi

Foreword.
When the cordless is waiting, i.and. when the line is not engaged and no operation is running,
the display shows:
• on the fi rst line: "PT(1) BS(1)"
(numbers identify the cordless (HS) and the base (BS). Or the name you have selected.
• on the second line: "14/10 14:09"
(14=day; 10=month; 14:09=present time), if you have adjusted them previously.
• Awhen a call comes in, the cordless will ring and the icon
If the cordless is connected directly to the telephone line (not through a PABX) and the
caller identifi cation service has been activated by your company, the caller's telephone
number will appear on the display (if it is available), or the caller's name, if it has been
previously stored in the number book.
• Press any button to answer, the display shows the icon
• To end the conversation, press the button
The icon wil disappear.
• Press the button to engag the line.
• With the line engaged, the display shows the icon
• Check that there id a dialing tone and dial the number using the buttons.
• The number selected will appear on the display.
• At the end of the conversation, press the button
the base, and the line will be disconnected.
The loudspeaker function is activated and deactivated pressing the button
line is engaged.
When the loudspeaker is activated, you hear the voice from the loudspeaker, and the
display shows the symbols
the loudspeaker volume).
During the conversation with the loudspeaker you can return to standard mode, pressing
again the button .
To end the conversation, press the button
• Before engaging the line, dial the number using the buttons, using a maximum of 24
fi gures.
• The fi gures appear on the display, and you can check them before engaging the line.
• If you dial a wrong fi gure, press the button CH- to cancel the last fi gure; to cancel all the
number, keep the button CH-, pressed, the number will be cancelled, and the device
returns to stand-by.
• After checking the number on the display, press display, press
• The fi gures will be selected.
• At the end of the conversation, place the cordless on the base and press the button
again.
NOTE: if your handset is connected to a PABX switchboard, to use the pre-selection button it
is necessary ton insert a pause of some seconds between the switchboard code and
the telephone number. Insert the pause, press the RP/P, button, the display shows the
letter " ".
P
Your cordless stores the last 10 numbers dialled, and gives you the possibility of recalling
them.
Foreword: If your handset is connected to a PABX switchboard, to recall the numbers of the
list it is necessary, while dialling the number, to insert a pause (pressing the button RP/P)
between the code accessing the outside line and the telephone number.
DC6010TR-lingue
6. U
SING THE "PHONE" FUNCTION

6.1 ANSWERING A CALL

or place the cordless back on the base.

6.2 MAKE A CALL WITH MANUAL SELECTION

6.3 CONVERSATION WITH SPEAKER

and (press repeatedly the buttons VOL+ and VOL+ to adjust
.

6.4 PRE-SELECTION

6.5 RP LIST: LAST NUMBERS CALLED

11
11
will fl ash on the display.
.
.
again or place the cordless back on
when the
to engag the line.
28-10-2005, 14:14