Adjustment Of Speaker Volume; Vibracall Function In Silent Mode; Microphone Exclusion; Cordless Search Function - BRONDI DC6010TR Mode D'emploi

With the handset in stand-by, press the button RP/P to access the list, the display shows on
the fi rst line the progressive number from 0 (more recent call) to 9 (less recent call) and on the
second line the telephone number.
Scroll the list by means of the buttons CH+ and CH-.
Press the button , the line will be engaged, and the number selected.
During a standard or loudspeaker telephone conversation, you can regulate the speaker
volume as follows: press repeatedly the button VOL+ o VOL-.
The volume levels appear on the display, as "
When the function is activated, the ring tone of the cordless is excluded and, upon arrival of
a call, the cordless vibrates.
To activate the Vibracall function, press and keep pressed the button
cordless vibrating for some seconds, and the display shows the symbol
To deactivate the function, press again and keep pressed the button
confi rmation tone, and the display shows the symbol
If you want, during a conversation you can exclude temporarily your partner pressing briefl y
the button /MUTE, the displasy shows "
Press again /MUTE, to deactivate the function and continue the phone conversation.
This function is useful, when you cannot fi nd your cordless.
• In standby mode, press and release the button
acoustic signal.
• To stop the signal, press any button on the cordless.
To avoid accidentally pressing the buttons on the cordless, it is possible to temporarily lock
them, in this way no operation can be performed, the line cannot be engaged and no
number can be selected.
• To lock the board, with handset in stanbdby, press and keep pressed for some seconds
the button ; you will heat a long confi rmation "beep", and the display shows for a
moment " ".
Key Lock
• To release the buttons, press the button
" ".
Buttons enabled

6.11 CORDLESS OPERATION UNDER PABX SWITCHBOARD: PAUSE FUNCTION

If your handset is connected to a PABX switchboard, during the number selection it is
necessary to insert a pause of some seconds between the switchboard code and the
telephone number.
To insert a pause, press the button RP/P, the display shows "
NOTE: A pause can be inserted only during the pre-selection, i.and. when the selection is
made on the disengaged line.
This button is useful to access the Supplementary Telephone Services offered by your
company; it is also necessary on some kinds of switchboard: pressing the button CH- when
the line is engaged, you send the R signal to the line (letter "F" on the display).
DC6010TR-lingue

6.6 ADJUSTMENT OF SPEAKER VOLUME

" followed by 1 (low), 2 (mid) or 3 (high).
Volume

6.7 VIBRACALL FUNCTION IN SILENT MODE

6.8 MICROPHONE EXCLUSION

" and the microphone is excluded.
Mute

6.9 CORDLESS SEARCH FUNCTION

6.10 BUTTON LOCK

, and hold it down, the display shows

6.12 R FUNCTION

12
12
, you feel the
.
, you hear a
.
on the base, the cordless will send an
".
P
28-10-2005, 14:14