Multi Flash Mode; Bounce Flash; Wireless Flash - Sigma EF-500 DG SUPER Mode D'emploi

MULTI FLASH MODE

While the shutter is open, the flash will fire repeatedly. By doing so a series of images of the subject will be
exposed in one frame. A dark background with a bright subject shows more effectively in this mode. It is
possible to set the firing frequency between 1Hz and 199Hz. Up to 100 flashes can be fired continuously.
The maximum number of flashes varies, depending on the flash guide number and firing frequency settings.
(Please refer to table3 on the last page).
This function cannot be used with EOS 700, 750, 850 cameras.
1. Set the camera's exposure mode to M mode, and set the F number
2. Press the MODE button until the Multi-flash mode appears
3. Press the SEL button until the flash firing frequency starts to blink.
4. Press the or
5. After pressing the SEL button again, the flash power level will blink.
6. Press the or
7. Press the SEL button again, the number of flashes will blink.
8. Press the or
9. Press the SEL button again, the display will stop blinking.
10. When the ready light of the flash is illuminated, the unit is ready to use.
Note: Please set the shutter speed longer than; Number of Flashes you want

BOUNCE FLASH

When you take a photo with flash in a room, sometimes a strong shadow will appear behind the subject, if
you point the flash head upwards or sideways to reflect the light off the ceiling, wall etc. the subject will be
illuminated softly. Press the lock button and adjust the flash head to set the bounce angle.
UP: 0°, 60°, 75°, 90°
RIGHT: 0°, 60°, 75°, 90
When the bounce flash mode is activated, a bounce indicator
appear on the LCD panel.
The picture will receive the color from the reflecting surface. Please
choose a white surface for bouncing.
Depending on the reflecting surface, the subject distance and other
factors, the effective distance range for the TTL AUTO may change.
Please check for correct exposure confirmation (ETTL or TTL mark on
the LCD panel) after releasing the shutter.
Close-up Exposures
For bounce flash can be tilted 7° downward for close-ups. The Flash will be effective only for the subjects
0.5 meter to 2 meters. When the flash head is tilted 7°

WIRELESS FLASH

When you use the "Wireless Flash" mode, you can take pictures with a more three-dimensional feeling by
shadow, or you can make natural image by shadow depending on the flash position, without any extension
cord connecting the camera body and flash. In case of EF-500 Super, communication between the camera
body and the flash will be done by the light of the flash. In the "Wireless Flash" mode, the camera will
calculate the correct exposure automatically.
The camera models of B type, can be used with "Wireless Manual Flash" and "Wireless Multi Flash"
functions only. The EOS750 and EOS850 cannot be used with "Wireless Flash".
In this instruction, we call a flash unit, which is attached to the camera body "Master unit ", and we call a
flash unit at a remote position "Slave unit".
When you set a slave unit at the desired position, you can use mini-stand. This mini-stand has a screw
hole for a tripod.
Place the slave flash unit at the desired location. Do not place the slave unit within the picture area.
Please set the flash unit within the range of 0.5m/1.5ft~5m/16ft from the subject and set the camera body
button to set the desired flash frequency value.
button to set the desired power level.
button to set the desired number of flashes.
DOWN: 0°,7°
LEFT: 0°, 60°, 75°,90°, 120°, 150°, 180°
will
will blink.
Firing Frequency
24