Motor Protection (Overload Protection Switch); Cleaning; Maintenance - ROTOR RBB 2 Mode D'emploi

© Rotor Lips AG
8. MOTOR PROTECTION (OVERLOAD PROTECTION SWITCH )
When the machine is overloaded or overheated, it switches off
automatically.
When the machine stops automatically, immediately remove the complete
container from the motor unit, pull out the plug and swich off the machine.
After about 60 seconds press the black button on the bottom plate
of the motor base and switch on the machine as usual.
Charge the machine less than before.
If you notice any irregularities or defects, please contact your
supplier. For more information see chapter "Repairs".

9. CLEANING

Pull out the plug before cleaning!
The motor unit must never be submerged in, or sprayed with water
or any other liquid! Never attempt to clean it with a water jet!
If necessary, clean the motor unit with a damp cloth.
Container: The mixing container should not be cleaned in the dishwasher while still
installed. They must first be dismantled.
The container should be cleaned thoroughly after each use or once a day.
Bowl: Can be cleaned in the dishwasher or clean by hand using hot water and a
commercial cleaning product.
Cutter assembly: simply rinse and, if necessary, scrub off. Never place
into water or the dishwasher.
Threaded ring: should be cleaned especially inside, by using a hard brush.

10. MAINTENANCE

The motor bearings are permanently lubricated and therefore require no maintenance.
16
Instruction Manual
Rotor Bar Blender
CH-3661 Uetendorf