ROTOR RBB 2 Mode D'emploi page 17

CH-3661 Uetendorf
Mix
- Insert the container into the retaining ring on the motor base, taking care to keep it
vertical.
- Add ingredients to be mixed.
- Place the mixing bowl on the rubber ring so that the switching rod to the bowl monitor
is pressed and the blender attachment is properly and securely fixed.
- Place the lid on firmly.
- Switch on motor (main switch "on") and vary the speed according to the ingredients
being mixed (selection switch).
- Turn off: at the main switch ("off").
- Remove the container from the motor base.
Liquids and fine grained materials can be added through the filler opening in the lid of
the container during operation (Remove the lid lock).
By switching on and while operating at high speed it is recommended that the bowl
should be held by hand (lay hand on the lid).
Never use the mixer without lid!
Hold the lid by hand!
To avoid heavy injuries or damages of the appliance, it is
forbidden, while mixing to reach into the container with
hands or with a hard solid object. This is although valid by
a standing still motor and assembled container, in case of
unintentional switching. Do not reach into the container with
a hard solid object by opening the lid lock.
The mixer should never run without container. Do not touch,
nor with any other object, the rotating coupling piece on top
of the motorbase.
Never put a cutter assembly on the motor base without
the container (extreme dangerous!)
Danger of scalding with hot drinks!
Container removal
First remove the complete container from the motor
base and empty it totally.
Attention: To disengage the plastic threaded ring,
turn to the right. Clockwise, like closing
a water tap, as the threaded ring is left-threaded!
Do not tear the handle (risk of breakage).
Instruction Manual
Rotor Bar Blender
© Rotor Lips AG
OPEN
TURN
RING
15