Stalgast 801350 Notice D'instruction page 35

– the set time is 90 seconds
– the set time is 120 seconds;
– the set time is 180 seconds;
The program is exited automatically 5 seconds after the selection of the desired cycle duration
5. Table of errors
Error code Error description
EP 1 fi lling time exceeded, but a second attempt was undertaken
EP 2 double fi lling time exceeded, attempts terminated
E1 LO temperature of probe T1 is too low (below 0°C) (or an open circuit in the probe)
E1 HI temperature of probe T1 is too high (above 110°C) (or a short circuit in the probe)
E2 LO temperature of probe T2 is too low (below 0°C) (or an open circuit in the probe)
E2 HI temperature of probe T2 is too high (above 110°C) (or a short circuit in the probe)
E3 LO
temperature of probe T3 is too low (below 0°C) (or an open circuit in the probe)
E3 HI temperature of probe T3 is too high (above 110°C) (or a short circuit in the probe)
E4 power outage during the operation of the dishwasher
Et boiler overheating
E1 temperature difference between probe T1 and T2 is too high (>30°C)
E2 safety temperature exceeded – error displayed after the completion of emergency rinsing
6. Start-up of the device
Turn on the switch located on the wall, open the dishwasher door, place the overfl ow plug in the appropriate place (fi g. 8)
and close the door of the device. Press the
boiler heating element will start operation. After the heating of water in the boiler is completed, the dishwasher chamber
water heating cycle will begin. Insert the basket into the device chamber and wait until the water in the chamber reaches
the set temperature. Before starting the wash cycle, it is necessary to select the program. The wash cycle is activated
automatically by opening and closing the dishwasher door. If the door is opened during the wash cycle, the program stops
automatically. After the door is closed, the program continues the wash cycle. The completion of the wash cycle program is
indicated by a sound signal from the control board. Remove the basket from the device chamber.
Water for washing
Water for rinsing/sanitizing
7. Emptying of the tank in models equipped with a drain pump
Turn the device off by pressing the
the door. Turn the drain pump on using the
is completely emptied of water. In order to reactivate the device, put the overfl ow plug back in its place, close the door and
press the On/Off switch. However, if the device will not be used any more, turn the main switch off.
8. Emptying of the tank in models not equipped with a drain pump
Turn the device off by pressing the
until the water is drained off completely from the tank. Put the overfl ow plug back in its place, close the door of the device.
Do not turn the device off when the water is still in the tank. Before turning the device off, always empty the tank
switch button . After the tank and the boiler are fi lled with water, the
60-65°C (140-149°F)
82-90°C (181-194°F)
switch , then open the door of the device, remove the overfl ow plug and close
button . The draining process proceeds automatically until the tank
the switch , then open the door of the device, remove the overfl ow plug and wait
- 35 -