Alecto DVC-180 Mode D'emploi page 70

5 RESET.
When contact with the camera is no longer possible and
you can no longer determine what the IP address or the
port number no longer corresponds, you can externally
reset the camera to restore the default factory settings.
There is a small hole on the back of the camera, just
above it SD slot with a push button underneath. Prick with
a small stick or a piece of it a paper clip on the key. Press this button when the
camera is fully started, and keep it pressed for at least 10 seconds until a beep
sounds is. The camera will restart.The camera can then only be accessed via
Wifi Direct. Now follow the registration process see section 3.
6 TO INSERT THE SD CARD.
At the side you'll find a slot for inserting a Micro SD card,
this card slot sits rather deep. You might have to use a small
screwdriver or tweezers to carefully press the card until it clicks
into the correct position.
70