Power Up; Operation - Macurco CD-12H Mode D'emploi

Masquer les pouces Voir aussi pour Macurco CD-12H:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.7.5
Alternate connection to the alarm panel
In this application
(3.2.7 Alternate connection to alarm
secondary relay is used as a supervisory relay when utilized in the normally closed configuration. The CD-12"x" monitors all critical
functions of the unit through software diagnostics that continually test and verify its operations. If a problem is found, the unit will switch
to a fail-safe/error mode or trouble condition. In this error mode, the Fan* and Alarm relays will be activated indicating the trouble condition
at the panel and the CD-12"x display will flash the error. *See the

3.8 Power Up

The CD-12"x" cycles through an internal self-test cycle for the first minute that it is powered. The unit will execute the test cycle any time
power is de-energized and re-energized (i.e. power failure). During the self-test cycle, the unit will display the firmware version number,
then count down from 60 to 0 (if the display setting is "On") and finally go into normal operation. The alarm relay will be activated for 10
seconds and the fan relay for 60 seconds during the power-up cycle unless the "Power Up Test" (PUt) option is OFF. The indicator light
(LED) will flash green during the self-test cycle. At the end of the 1-minute cycle, the unit will take its first sample of the air and the
indicator light will turn solid green.

3.9 Operation

1. With the display function turned "On", the CD-12"x" will show the current concentration of CO
concentration ranges between 350-450 ppm. When the CO
example) the display will flash back and forth between "FAn" and "2000". With the display function turned "Off", the display
does not show the CO
2. With the display function turned "On" and the CO
the display will flash back and forth between "ALr" and "4000". The buzzer will sound indicating "Alarm" if the buzzer is turned
"On". With the display function turned off the display does not show the CO
relay is activated.
panel) the Fan or primary relay is used as a low-level alarm relay. The Alarm or
concentration but will show "FAn" as long as the fan relay is activated.
2
2
Trouble Fan Setting
Option.
concentration reaches the Fan Relay setting (2000ppm, for
2
concentration reaching the Alarm Relay setting, (4000 ppm, for example)
concentration, but will show "ALr" when the Alarm
2
10
ppm in the air. Normal outdoor
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Macurco cd-12mc

Table des Matières