OHAUS SD Série Mode D'emploi page 9

Battery Installation (Optional)
• Open the battery cover on the bottom of the Indcator and nstall three "C"
sze (LR14) alkalne batteres nto the compartment. Orent the batteres as
shown on the nsde cover. Close the battery cover.
NOTE: Batteres are not ncluded.
CAUTION: Do not dispose of used batteries in domestic waste. Follow
the proper disposal or recycling requirements in accordance with local
laws and regulations.
Indicator Mounting and Placement Options
• Table Top Placement:
The Indcator may be placed on a flat table surface wthout addtonal
hardware. Four rubber feet provde reduced slppage on most surfaces.
• Direct Wall Mounting:
The Indcator may be mounted drectly to a wall usng two screws (not
ncluded). Select approprate sze screws that ft nto the holes at the bottom
of the Indcator housng. See Fgure 3. When mountng to a wall wthout a
sold backng, use approprate anchorng hardware.
Fgure 2. Battery Installaton.
SD SERIES BENCH SCALE EN-3